Kenco-engineering KMD Transmitter Manuale Utente Scaricare il pdf (Pagina 14)

Page 14

Advanced

Click the Advanced Setup Tab. Confirm that the Gradient, Length, and Head Adder have been received from the

transmitter. If not, click the Read Button. The fields are defined as follows:

Gradient -- Is slightly different fro each sensor. This number can be found on the sensor element head.

Units -- Determines the unit of measure for “Length” and “Head Adder”. See the section on “Output Tab” to

change the unit of measure for all data.

Head Adder -- The difference between the sensor length and the order length; approximately 5.6”.

Display Units -- The units shown on the optional display.

Float #2 -- Enable/Disable optional second float.

Temperature -- Enable/Disable optional temperature measurement. Cannot be used unless and RTD was ordered

with the sensor.

Display -- Enable/Disable optional display.

Alarm -- Determines the condition of the output current upon detection of a fault (sensor / electronics error).

1 2 ... 9 10 11 12 13 14 15 16 17

Nessun commento

Kenco-engineering KMD Transmitter Manuale Utente Pagina 14